LEDs control module

It\'s tiny (15.5 x 6.6 x 2.5mm) module for controlling 15 LEDs. Module can be programmed by PC software and after it, it runs on it\'s own. It was projected to be small enought to be located inside plastic model (ex planes in 1:144 scale) and runs just after power up.

  • size: 15.5 x 6.6 x 2.5mm
  • power: 3..5V (ex. from USB charger)
  • operate with max 15 LEDs (3V; 6 of them cound be 5V - it\'s important for ex. white and blue LEDs)
  • output pads are in every border on both sides
  • there is one two-way line to connect module to PC (or other device); there is possibility to update firmware and send settings
  • two-way line can be shared by several modules
  • every single LED can have it\'s own alghoritm (max 32 steps)
  • a lot of options for each led like time divisors, blinking, fading, limiting brightness

To program module you should connect it to PC by transmission line; you can use ex. USB<->TTL converter.

I will show here photos of plastic model with this device inside.

Additional photos:
Configuration program for PC: (it will be also in english)

Copyright 2009-2013 Paweł Konarski